Installation Of Continuous Level Sensor Guided Wave Radar

Continuous level sensor guided wave radar is a high-precision liquid level measurement equipment widely used in industrial fields. The correct installation and debugging of Guided wave radar level gauge is crucial to ensure its normal operation and accurate measurement. When installing a guided wave radar level transmitter, certain steps need to be followed.

The first step is to determine the installation location. The liquid level gauge should be installed to the side of the liquid to be measured and keep a certain distance from the liquid to be measured to avoid the interference of the liquid level gauge to the liquid level gauge.

The second step is to install the waveguide. The waveguide should be installed above the liquid to be measured and fixed to ensure the quality of signal transmission. Next, connect the power cable and signal cable of the Guided wave radar level gauge to the corresponding interface, and pay attention to the polarity of the power and signal cable when connecting.

The third step is initial setup and debugging calibration to ensure accurate and reliable measurement results.

In order to ensure the accurate measurement of the continuous level sensor guided wave radar, it is first necessary to perform initial settings, including zero calibration and parameter settings for the liquid medium. Secondly, perform debugging and calibration. During the debugging and calibration process, the influence of the liquid to be measured should be avoided as much as possible, and air measurement without medium should be adopted. During the calibration process, you need to pay attention to several aspects: first, when adjusting the liquid level meter, you need to wait for a certain period of time to ensure that the medium of the measured object is evenly distributed and avoid the impact of noise on the liquid level meter; secondly, adjust the angle of the waveguide , ensure that the waveguide is perpendicular to the liquid being measured, thereby improving measurement accuracy; finally, before measurement, a comprehensive inspection and test should be conducted to ensure that the liquid level meter is working properly.

The correct installation and debugging of continuous level sensor guided wave radar is the key to ensuring its normal operation and accurate measurement. Following the correct installation steps and details can help you make better use of the guided wave radar level transmitter and improve production efficiency and quality.