Precautions For The Operation And Use Of The Acid Dew Point Meter

Please read the following content and safety instructions in detail before using the acid dew point meter. If you have any questions, please contact us immediately.

1. The heater of the acid dew point sensor is heated by high voltage electricity. Improper maintenance and measurement will cause life-threatening to relevant personnel. Be sure to pay attention to safety. Generally, the power must be turned off before measurement. The grounding wire of the sensor must be reliably grounded. The operator must be a licensed professional in electrical maintenance. Any consequences caused by improper operation shall be the responsibility of the operator or the user.

2. Improper installation of the combustion control system may cause danger. When the combustion is lacking in oxygen, be especially careful of carbon monoxide CO. When the CO value is greater than 400PPM, it will kill people. All installers must install and adjust according to the requirements of the drawing. If necessary, the corresponding alarm device must be installed. The user is responsible for any consequences of improper use.

3. Because the heater of the sensor will generate a high temperature higher than 700℃, an explosion may occur when the gas fuel leaks, so the sensor must be connected to the heater after the furnace fire is ignited. The SLDA 2100 acid dew point meter has a related heater connection control switch. The installer and user must be clear about the conditions of use. The user is responsible for any results of improper use.

4. When measuring low-oxygen fuels, pay special attention to the output signals and alarm signals of the acid dew point meter and the acid dew point sensor. When the combustion is incomplete, the measured value of the sensor may deviate. If you have any questions, you must ask the relevant professionals. If the user uses it improperly, the user is responsible for any results.

5. When the pressure at the measuring part is not atmospheric pressure, the measured acid dew point value will have a corresponding deviation. The acid dew point meter can give corresponding compensation, but the user must set it correctly. Incorrect settings will produce wrong measurement results. The user is responsible for any results of improper settings.

When the acid dew point sensor and instrument are used in the explosion-proof area, the explosion-proof box must be configured according to the specific requirements of explosion-proof. The user is responsible for any results of the incorrectly configured explosion-proof box. The heater of the explosion-proof sensor must be turned on for heating after the fire is burning.